You can set the SNMP network management protocol to get the alarm event and exception messages in network transmission.
Before You Start
Before setting the SNMP, you should download the SNMP software and manage to receive the device information via SNMP port.
Steps
1. Go to the settings page: Configuration → Network → Advanced Settings → SNMP.
2. Check Enable SNMPv1, Enable SNMP v2c or Enable SNMPv3.
Note
The SNMP version you select should be the same as that of the SNMP software.
And you also need to use the different version according to the security level required. SNMP v1 is not secure and SNMP v2 requires password for access. And SNMP v3 provides encryption and if you use the third version, HTTPS protocol must be enabled.
3. Configure the SNMP settings.
4. Click Save.