If you want to link two locations together on a network and cabling is impossible or not economic then IPmitter wireless bridges are a great choice. They allow you to link IP CCTV from one building to another or simply to link your garden office to your main house for internet.
Our budget IPmitters have a data transfer rate of 300Mbs, using the 2.4Ghz band, this is aimed at cost conscious installations.
The Standard IPmitters have a faster data transfer rate of 450Mbps and uses the less crowded 5.8GHz band so is less likely to be fighting for airspace in areas that have a lot of WiFi equipment. **OFFER** Spend over £300 ex-vat on IPmitter branded products and get a free patch lead bundle worth £28!!
These are the top of the range IPmitter bridges and boast an ultra fast 900Mbs data rate and also uses the 5.8GHz band for a less crowded airspace footprint. The 1Gig LAN port also makes this model more suitable for multiple IP camera transmission. **OFFER** Spend over £300 ex-vat on IPmitter branded products and get a free patch lead bundle worth £28!!
Ideal for pole mounting CCTV equipment such as the IPmitter wireless bridges and antennas.
Below are a list of product manuals and quick start guides covering our IPmitter wireless bridges and wireless access point range.
The above manuals cover the following models: IPMIT100
The above manual covers the following models: IPMIT204 / IPMIT254
The above manual covers the following models: IPMIT304 / IPMIT354
The above manual covers the following models: IPMIT430 / IPMIT460
Budget 24V PoE Wireless Bridges - Full Manual (PDF)
The above manual covers the following models: IPMIT200 / IPMIT250
Standard 24V PoE Wireless Bridges - Full Manual (PDF)
The above manual covers the following models: IPMIT300 / IPMIT350
No not at all.
All 3 IPmitter models boast a superb easy pairing method which means you can set up the IPmitter without needing a laptop or PC to set up its IP address, perfect for getting the job done more efficiently and without needing a dedicated IP technician to do the install.
Pairing on channel 100
1. Power both IPmitters, and leave to boot up for at least 3 mins. During boot up they will display a rotating segment [ _i]
2. On one IPmitter (client), press the F (function) button and "H" will flash [H 100]. Press the S (setting) button to change to [C 100].
3. The whole display will flash to indicate the settings have been saved, it will reboot (can take up to 3 mins) then the display will show [C036].
4. Now press the RST (reset) button for 1 second on both IPmitters [H 100] [C036].
The display will change to a P with a rotating segment whilst pairing [P __]. Pairing can take up to 5 minutes.
The display will show P and a value once paired [P0 10] [P0 12].
More information for the general public at our website: www.ipmitter.com
© 2022 Systemq.com, all rights reserved worldwide.