Low cost IP PoE extenders. Add on the end of a 100M run to extend the run by a further 100M. Cascade up to 2 for a 300M run.
An account is required to purchase this item. Use the buttons below to login to an account, or to create an account.
PoE network cable runs are usually limited to around 100m maximum length which on a large industrial unit by the time the cables have been routed out of the way can be a little limiting.
This ScatterBox PoE extender can go 3x as far to create cable runs up to an amazing 300m. The small in-line unit requires no external power source so it can be fitted almost anywhere along the existing network cable run to make a quick and easy installation.
Up to 2 units can be used on a run to reach up to 300m with each extender connected to the end of a 100m max cable run to boost the power and data for another 100m.
For additional flexibility this unit is compatible with PoE Splitters to power non-PoE cameras requiring 660mA or less on runs up to 200m.
This extender can be used on 10 & 100 Mbps networks.
Very useful PoE extender and 4 way splitter. Add on to the end of a 100M run to extend into 4 more 100m runs. Note the output has a max power of 22W shared over the 4 outputs. If you need more power and a full 1 Gig solution have a look at our POE154 rated at 60W output.
Handy High Speed IP PoE Extender and 2 way splitter. Full 1 Gig in and out this is a really useful piece of kit for both extending PoE past the 100m mark and also adding on a 2nd IP device or connection. Powered by the inbound IP for ease of installation.
This handy PoE switch is actually powered by its incoming PoE connection, so you can install it anywhere along a PoE cable run as a 4 way switch without having to worry about how to power it. It also then re-distributes its PoE input to power 4 more PoE devices, how clever is that?!