Location
Home / IP CCTV / IP Switches etc / PoE Injectors / POE200 - Gigabit PoE Injector

Gigabit PoE Injector

Gigabit PoE Injector

... great for adding a power source into network

  • Mid or End Span Pairings
  • Up to 200M Runs
  • Simple In-Line Design
  • 2A Loads

Add 30W of power into a network allowing PoE cameras to be added on to the cable run after it. Runs of 100M in and out of the device are easily achievable on a standard 100Mbps network.

An account is required to purchase this item. Use the buttons below to login to an account, or to create an account.

Learn More

The POE200 injector can add 30W of power into a network allowing PoE cameras to be added on to the cable run after it. Runs of 100M in and out of the device are easily achievable on a standard 100Mbps network & it can be used as a mid or end span device after upper network switches.

Power over Ethernet (PoE) is a great method of supplying power to network video equipment such as IP cameras as it does away with the need for a power source local to the camera, or installing extra power cable runs to the device.

In some networks the cabling infrastructure may not be PoE so the use of a PoE injector (also known as a PoE end-span or mid-span device) such as the POE200 can be a great way to overcome this.

Simply plug the non-PoE uplink cable from, say a network switch, into the RJ45 input and the camera into the RJ45 output then connect the power lead supplied and power up, the POE200 PoE Injector is fast to install and requires no real set up. The injector uses either the spare line/end-span pair 4/5 (+), 7/8 (-) method or the data line/mid-span pair 1/2(+), 3/6(-) method to run the power.

With the ability to produce a up to 100M output with a 2A load, this offers a great solution where a PSU cannot be installed next to a PoE camera.

Compatible on 10, 100Mbps networks with maximum runs of 200 metres (100m in & 100m out) and 1000Mbps networks up to 162 metres (81m in & 81m out), this is a great unit to keep in your toolbox for an IP CCTV installer.

Specifications
FAQ

You Might Also Like...

High Load Capacity 71W Gigabit 6 Port PoE Switch

Very powerful 1Gbps 4 way switch that can supply up to 71W of power per port. Designed for higher load PoE CCTV equipment.

In Stock
Budget PoE Switches

Great for smaller or domestic installs these 6 or 10 port switches can be connected directly to the NVR for a local system or networked via a router.

In Stock
High Load Capacity Gigabit PoE Switches

ScatterBox Gigabit PoE switches have been specifically tailored for powering and connecting IP CCTV cameras to a network thanks to their high speed capacity and high load capacity.

In Stock
Search
Login Status
Categories

© 2021 Systemq.com, all rights reserved worldwide.

Software: Kryptronic eCommerce, Copyright 1999-2021 Kryptronic, Inc. Exec Time: 0.028086 Seconds Memory Usage: 1.570953 Megabytes
Kryptronic