User Information

•Please read the operation manual carefully before installing and operating the product.

•The camera must not be exposed to conditions above the IP66 rating.

•The PTZM600 requires a 12V DC 2A power supply as a minimum. (The cameras maximum draw is 1.7A). The correct 12V DC 2A rated power supply is provided with each PTZM600.

•Do not connect 24V AC to this camera under any circumstances

•Take care when transporting, storing and installing the PTZ. Avoid subjecting the PTZ to vibration or weight pressure, which can cause damage to the optical and electronic equipment inside the PTZ.

•Always use and stick to current electrical safety standards when installing. (BS EN 62676-1-1) (BS EN 62676-4) (BS8418)

•The RS-485 and video signal cables should be kept way from high voltage equipment such as mains cables or lighting circuits.

•Using an anti-surge protection device is recommended to prevent damage to the PTZ camera from lightning and mains surges. Electrical damage to units by lightning or mains voltage surges is not covered under the product warranty.

•There are no user serviceable parts in the camera and opening or attempting to repair the product will void the warranty.

•Do not touch the camera connections with wet hands.

•Do not operate in areas exceeding the stipulated limitations concerning temperature, humidity. The camera working temperature outdoor is -20°C ~ +60°C and humidity must be less than 90% (frostless).

•Do not aim the camera directly towards the sun or an extreme light source whether it is switched on or not. Do not let the camera focus on bright and stationary objects for a long time. Doing any of these, may damage the filter on the sensor that may cause colour loss.

•Do not use strong detergents to clean the main body of the camera as these may damage the PTZ paintwork. Wipe dirt away with a damp micro-fibrecloth. If needed a soapy water can be used.

•Do not install or use the camera if the cables, casing of the PTZ, or the power supply is damaged.

•When this unit is in use, avoid direct eye contact with the infrared lights.

•The unit’s outer IR transparent cover can heat up when in use and care should be taken to ensure that this PTZ is fitted where it cannot be easily touched. It must also not be fitted in close proximity to any flammable materials.