<< Click to Display Table of Contents >> Navigation:  Temperature Measurement > Automatic Thermography > Set Expert Mode

 

Select the temperature measurement rules from Point, Line, or Area and configure parameters, the device alarms if the alarm rules are met.

 

Steps

1. Go to Configuration → Temperature Measurement → Basic Settings, check Enable

Temperature Measurement.

2. Refer to Set Thermography Parameters to set the parameters.

3. Go to Configuration → Temperature Measurement → Advanced Settings, select Expert.

4. Select and enable the temperature measurement rules. Please refer to Set Thermography Rule

for setting the rule.

5. Optional: Click Area's Temperature Comparison to set the alarm rules and the temperature.

6. Refer to Set Arming Schedule for setting scheduled time. Refer to Linkage Method Settings for setting linkage method.

7. Click Save.

The maximum temperature and thermography rules will be displayed on the liveview.

 

 

 

Note

Go to Image → VCA Rules Display to adjust the fonts size and the temperature colour of normal, alarm and pre-alarm.