The MegaMitters are supplied bench tested, and pre-paired. Only one Receiver (RX) can receive video from one Transmitter (TX), ensuring private secure connections.
When both the TX & RX are powered up and in within transmission range of each other the green light will illuminate to indicate they are connected.
Pairing Process
As supplied the MIT500s are already paired, but if they do need pairing follow the process below;
1. Connect AHD Video into the Tx. Connect 12V DC Power to both Tx and Rx. Press the PAIR 
button down on the RECEIVER for 3 seconds. The Link LED will start to flash.
2. A countdown will start for 30 seconds, then press and hold the PAIR button on the TRANSMITTER until the link LED starts flashing.
3. Once pairing is complete both Link LEDs will display solid Green. If a monitor is connected to the RECEIVER it will display a signal strength bar at the top left hand corner of the display.